ENGLISH / A-13
FORM NO. 56041980 - CS7000 - A-13
PRE-OPERATIONAL CHECKLIST
Before Each Use:
* Inspect the machine for damage, oil or coolant leaks.
* Squeeze the rubber dust cup on the Engine Air Filter (48) to release built-up dust.
* Check the Air Filter Service Indicator (29).
* Check the engine coolant level (22).
* Check the engine oil level (50).
* Check the hydraulic oil level.
* Check the Fuel Gauge (C6) on the diesel models.
* Check the Fuel Gauge located on the LPG tank (31) for propane model.
* Check the Battery Charge Level (C5) on battery models.
* Make sure the battery charger is not connected to the machine.
* Make sure the recovery tank is empty.
In the Driver’s Seat:
* Be sure that you understand the operating controls and their functions.
* Adjust the seat to allow easy reach of all controls.
* Insert the Master Key and turn the Ignition Key Switch (A) to the ON position. Check for proper operation of the Horn (M), Hour Meter (C3 or
C4) and Headlights (L). Turn the Ignition Key Switch (A) OFF.
* Check the Brake Pedal (38). The pedal should be f rm and should not go all the way down. The latch should hold the pedal when applied.
(Report all defects immediately to service personnel).
Plan Your Cleaning in Advance:
* Arrange long runs with a minimum of stopping or starting.
* Allow 6 inches (15 cm) of broom path overlap to ensure complete coverage.
* Avoid making sharp turns, bumping into posts, or scraping the side of the machine.
To Next Page
Loading...
Need help?
General
