To Next PageTo Next PageWhat causes M6 Open error on Nilfisk-Advance Scrubber?
If no broken connection is located, this could also be caused from the limit cams inside the actuator to be misadjusted, which could prevent the actuator from being neither raised nor lowered.
Why is my Nilfisk-Advance SC6000 910C Scrubber showing an M1 Overload error?
The most common cause for the M1 Overload error is when the motor is experiencing an obstruction, binding, or under excessive load. Check for obstructions or excessive load on the motor.
What to do if Nilfisk-Advance Scrubber shows K1 Contact Weld?
Disconnect the relay output wires. If the condition persists, then it is known to be a short in the wires. If the condition clears after disconnecting the output wires, then it is known that the contacts have fused and the relay must be replaced.
How do I troubleshoot a K1 Coil Short in my Nilfisk-Advance SC6000 910C Scrubber?
Inspect the wires between the controller and the relay (also located in the steering column) for shorts. Otherwise, replace the relay.
How to fix K1 Coil Open on Nilfisk-Advance Scrubber?
The most likely cause of K1 Coil Open is a loose wire. Ensure that all connections are secure and there are no loose wires.
What does M8 Short mean on a Nilfisk-Advance SC6000 910C?
The most likely cause of M8 Short is a loose wire at the pump touching the other terminal. Swap the pump wires (pump 1 for 2) according to the color codes. If the controller thinks the same pump is faulty, then you know the short is in the wires. If the controller thinks the other pump is faulty, then you know that one of them is faulty.
What does LP1,2 Short mean on Nilfisk-Advance SC6000 910C Scrubber and how do I fix it?
The most likely cause of LP1,2 Short is a short in the wires leading to the headlight due to chaffing or melting. Disconnect both headlights. If the condition clears, at least one of the headlights is faulty.
What does H1 Short mean for Nilfisk-Advance SC6000 910C?
The most likely cause of H1 Short is a damaged coil with an internal short. Check the coil resistance of the horn. If it is significantly below the normal coil resistance of 5.8 ?, then replace the horn.
What does H2 Short mean on my Nilfisk-Advance SC6000 910C Scrubber?
The most likely cause of H2 Short is a damaged coil with an internal short. Check the coil resistance of the horn. If it is significantly below the normal coil resistance of 5.8 ?, then replace the horn.
What causes L2 Short in Nilfisk-Advance SC6000 910C and what should I do?
The most likely cause of L2 Short is a damaged solenoid with an internal short. Check the coil resistance of the solenoid. If it is significantly below the normal coil resistance of 126 ?, then replace the solenoid.
General| Model | SC6000 910C |
|---|---|
| Type | Scrubber |
| Power Source | Battery |
| Battery Voltage | 24 V |
| Sound Level | 68 dB |
| Drive Speed | 6 km/h |
Explanation of safety symbols and essential operational safety guidelines.
Description of the main controls and switches on the operator panel.
Explanation of the various indicators and data displayed on the machine's screen.
How to access and navigate the machine's information and settings menu.
Explanation of the magnetic smart key system for machine operation.
Detailed steps for performing scrubbing tasks, including safety and adjustments.
Daily, weekly, monthly, and yearly maintenance tasks for the machine.
Common problems and their corresponding causes and remedies.
Explanation of fault code structure, display, and common codes.
How to access and view the machine's fault history log.
