Nilfisk-ALTO Attix 30 XC User Manual (English)

Other manuals for Nilfisk-ALTO Attix 30 XC

Questions and Answers:

A
Adam CoxSep 6, 2025
What to do if my Nilfisk-ALTO Attix 30 XC motor does not start?
- P
  Patrick CastroSep 6, 2025
  If the motor of your Nilfisk-ALTO Vacuum Cleaner fails to start, there are a few potential causes: * The fuse in the mains socket may have blown; connect a mains fuse. * The overload protection switch may have tripped; switch off the vacuum cleaner and allow it to cool for approximately 5 minutes. If it still doesn't start, contact Nilfisk-Alto service. * The motor itself might be faulty; have it changed by Nilfisk-Alto Service.
D
danielwilkinsSep 7, 2025
What to do if my Nilfisk-ALTO Attix 30 XC Vacuum Cleaner has no suction power during wet cleaning?
- A
  Alexander DavisSep 7, 2025
  If your Nilfisk-ALTO Vacuum Cleaner lacks suction power during wet cleaning, it's likely that the tank is full. To resolve this, switch off the cleaner and empty the tank.
J
James OneillSep 9, 2025
How to fix voltage fluctuations in Nilfisk-ALTO Vacuum Cleaner?
- S
  Sharon MasonSep 9, 2025
  To address voltage fluctuations with your Nilfisk-ALTO Vacuum Cleaner, connect the cleaner to another socket closer to the fuse box. Voltage fluctuations over 7% should not occur if the impedance at the transfer point is ? 0.15 ?.
A
ashleyramirezSep 12, 2025
What to do if my Nilfisk-ALTO Vacuum Cleaner has reduced suction and acoustic warnings?
- L
  Lori BaldwinSep 12, 2025
  If you hear acoustic warnings and notice reduced suction power in your Nilfisk-ALTO Vacuum Cleaner, several factors could be the cause. First, the suction power selected might be too low, so adjust it according to the manual's instructions. Also, the hose diameter might not match the switch position, so set the correct switch position. Check for clogs in the suction hose or nozzle and clean them if necessary. Make sure that the tank, disposal bag, or filter bag is not full. Also, the filter element may be clogged, so clean or replace it as described in the manual. Finally, make sure that the seal between the tank and the upper section of the vacuum cleaner is intact; if it's faulty or missing, replace it.
S
Sharon GloverSep 12, 2025
Why doesn't my Nilfisk-ALTO Vacuum Cleaner motor run in automatic mode?
- J
  James LopezSep 12, 2025
  If your Nilfisk-ALTO Vacuum Cleaner motor doesn't run in automatic mode, it could be due to a defective or improperly connected power or pneumatic tool; ensure the power tool functions correctly and is properly plugged in. Alternatively, the electrical tool's power rating might be too low; ensure it exceeds the minimum rating of P>40W.
M
melissaburnsSep 14, 2025
How to fix voltage fluctuations in my Nilfisk-ALTO Vacuum Cleaner?
- M
  Margaret SwansonSep 14, 2025
  If you experience voltage fluctuations with your Nilfisk-ALTO Vacuum Cleaner, it's likely due to high impedance in the power supply. To resolve this, connect the cleaner to another socket closer to the fuse box.

Nilfisk-ALTO Attix 30 XC Specifications

General

Model	Attix 30 XC
Category	Vacuum Cleaner
Voltage	230 V
Frequency	50-60 Hz
Airflow	3700 l/min
Vacuum	250 mbar
Container Capacity	30 l
Hose Length	2.5 m
Cord Length	7.5 m
Filter Type	PET Fleece Filter Bag
Accessories	Crevice nozzle