EasyManuals Logo

Nilfisk-ALTO SCRUBTEC 343B User Manual

Nilfisk-ALTO SCRUBTEC 343B
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #63 background imageLoading...
Page #63 background image
16 SCRUBTEC 343B 909 6313 000(2)2007-06 A
ENGLISH USER MANUAL
MACHINE LONG INACTIVITY
If the machine is not going to be used for more than 30 days, proceed as follows:
Perform the procedures shown in After Using the Machine paragraph.
Remove the recovery water tank (31) as shown in the previous paragraph, and then disconnect the battery negative terminals
(10).
Install the recovery water tank (A).
Store the machine in a clean and dry place.
FIRST PERIOD OF USE
After the fi rst 8 hours, check the machine fastening and connecting parts for proper tightening. Check the visible parts for integrity
and leakage.
MAINTENANCE
The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance. The following chart
provides the scheduled maintenance. The intervals shown may vary according to particular working conditions, which are to be
defi ned by the person in charge of the maintenance.
WARNING!
Maintenance procedures must be performed with the machine switched off and the batteries/battery charger
cable disconnected.
Moreover, carefully read the instructions in the Safety chapter.
All scheduled or extraordinary maintenance procedures must be performed by qualifi ed personnel, or by an authorised Service
Centre. This Manual describes only the easier and most common maintenance procedures.
NOTE
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can
be consulted at any Service Center.
SCHEDULED MAINTENANCE TABLE
Procedure
Daily, after using
the machine
Weekly
Every six
months
Yearly
Squeegee cleaning
Brush cleaning
Tank and vacuum grid cleaning
Squeegee blade check and replacement
Solution lter cleaning
Battery charging
WET battery fl uid level check
Screw and nut tightening check (1)
Brush motor carbon brush check and replacement (2)
Vacuum system motor carbon brush check and replacement (2)
(1) And after the fi rst 8 working hours.
(2) This maintenance procedure must be performed by Alto authorised Service Center.
1.
2.
3.
4.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nilfisk-ALTO SCRUBTEC 343B and is the answer not in the manual?

Nilfisk-ALTO SCRUBTEC 343B Specifications

General IconGeneral
BrandNilfisk-ALTO
ModelSCRUBTEC 343B
CategoryScrubber
LanguageEnglish

Related product manuals