21
BREAKDOWNS
Protection against overheating
The drying cabinet is equipped with an overheating protection device which trips if
the temperature in the cabinet becomes too high. When the protection device trips,
the power supply to the drying cabinet main power switch (1) is interrupted and
the green indicator light (2) goes out. In this case the drying cabinet will not start.
When the temperature in the drying cabinet has sunk to an acceptable level, the
overheating protection device is reset automatically and the green indicator (2)
lights up (N.B.! If the main power switch (1) is on the ON position - pressed in).
It takes about 15-20 minutes for the temperature to sink to an acceptable level.
Therefore, if the drying cabinet has recently been used and if the green indicator
(2) will not light up with the main power switch (1), always wait a minimum of 20
minutes. Then make a new attempt to start it before reporting the fault.
If repeated breakdowns occur, contact your supplier.
The two automatic programmes of the drying cabinet can be optimised to match
the installation conditions.
To do this, use the control panel to adjust the parameter values for the relevant
automatic programme.
Only do this if you think that:
The washing is not being suciently dried
The washing is being over-dried – excessive drying time.
See the parameter adjustment instructions on page 26.
AUTOMATIC PROGRAMMES SETTING THE PARAMETERS
USING THE ETS 1700E / ETS 1900E DRYING CABINET
To Next Page
Loading...
