15
The drying cabinet should be connec-
ted to a 230 V single-phase 50 - 60 Hz
grounded socket.
The drying cabinet is supplied ready for
connection with a cable with a groun-
ded plug.
ELECTRICAL CONNECTIONS
The manufacturer cannot be held liable if
the electrical connections are not carried
out as prescribed in this manual.
Check that the supply current matches
that stated on the identification plate and
that the mains lead is grounded correctly
according to standards in force. We
recommend that the mains lead be fitted
with a residual current device (RCD).
Appliance must be connected to a
dedicated circuit.
The socket should be located where the
plug can be easily disconnected when
required.
The drying cabinet should be connected
using the plug supplied to a grounded wall
socket, and should not be permanently
connected.
INSTALLATION
If the power cable is damaged in any
way, it must be replaced. Genuine re-
placement power cables are available
from your dealer.
NOTE Replacement power cables
should only be replaced by a
qualied electrician!
To Next Page
Loading...
