26
INTRODUCTION
The drying cabinet has two automatic
programmes, one for 40 °C and one
for 60 °C.
The automatic programmes end when
the washing is dry.
To determine when the washing is dry,
the programmes measure the tempera-
ture in the exhaust duct of the drying
cabinet and compare it with a parameter
set at the factory,
parameter P4 for the 40 °C
programme and
parameter P8 for the 60 °C
programme.
These are the two main parameters
to be adjusted to optimise the drying
process of the automatic programme.
If you think that the washing is not
being sufficiently dried, increase
the value of the parameter for the
relevant programme.
If you think that the washing is being
over-dried (long drying time), reduce
the value of the parameter for the
relevant programme.
Drying processes should always be opti-
mised in small steps. Begin by adjusting
the relevant parameter up or down by 1
to 2 units. Then check the result after the
next drying process and adjust further if
necessary.
PARAMETER ADJUSTMENT ETS 1700E / 1900E
To Next Page
Loading...
