Usermanual NIMOS Micro-Trac Page 11
) IMPORTANT! Don’t change gears during driving. When shifting, move the lever cautiously in
the outmost position. When the lever is not well engaged, it can move to neutral
position, so the hydrostatic driving and braking will not function!
4 How to use your machine
4.1 Starting
¾Switch all hydraulic functions (switches 20 to 23, 44 to 45) off, move the speed control pedal (10) to the
neutral position and engage the parking brake (13).
¾Read also the operation manual engine for further instructions.
¾Check if the warning lamps of the charging current (32) and the oil pressure (34) light when you turn the key
(29) to ON position and the engine doesn't run.
¾GASOLINE:Move throttle lever (11) to medium position, and pull choke out if starting a cold engine and start
the engine. Push choke in immediately after starting.
¾DIESEL:Move throttle lever (11) to medium position, turn key to PRE-HEAT position and hold until lamp (35)
goes out and start the engine.
¾Allow engine and hydraulic oil to warm up for a few minutes with throttle lever in medium position. Move all
cylinders totally in and out before you go driving.
4.2 Stopping
¾Switch all hydraulic functions off, engage the parking brake, shut off the engine and remove the key.
4.3 Driving
Shifting high and low gearing
Low gearing: press the lever (12) to the left and move it into the lowest position. Use this gearing for driving over
beaten roads and with light load.
Low gearing: press lever (12) to the left and move it into the upper position. Use this gearing for off-road driving,
on slopes and at heavy load or with trailer.
Neutral position: when lever (12) is in the medium position, the transmission is shifted neutral. The hydrostatic
driving and braking don't function.
4.4 Speed control:
With the drive pedal (10) you control the driving speed together with the revolutions of the engine. Forward
kicking moves the machine forward. Backward kicking moves the transporter backward. In the neutral position
the machine brakes (working brake).
4.5 Brake padel:
Use the brake pedal (18) to stop the machine in a short time. This brake is emergency brake if the hydraulics
should fail.
4.6 Parking brake:
Press the brake pedal (18) full down and move the lever of the parking brake (13) down, so that the pedal is set
in the lower position. To disengage the parking brake, press the brake pedal (18) full down and move the lever
of the parking brake (13) upward.
) NOTE! Let the engine run after heavy load to cool the machine.
To Next Page
Loading...