19
www.ninjakitchen.com
USING THE DISCS
NOTE: Disc attachments must be used with the
feed chute lid.
IMPORTANT: Use only the High setting when using
either disc.
1 Place the motor base on a clean, dry, level surface such
as a counter or table top. (Fig. 5)
2 Secure the bowl onto the motor base.
3 Place the spindle inside the bowl.
4 Use the finger holes to grasp the selected disc and
place it over the spindle.
5 Place the feed chute lid on the bowl and turn clockwise
until you here a click indicating the lid is locked in
place. (Fig. 5)
6 Plug the power cord into the electrical outlet and press
up on the power toggle (
) to turn the power “On”.
7 Select HIGH on the control panel. The discs will begin
spinning.
8 Add the food that you want to slice, shred or grate
through the feed chute on the lid. (Fig. 5) Use the
two-part food pusher to help guide the food through
the feed chute. The middle piece of the food pusher is
removable to use for smaller ingredients.
9 When finished,stop the appliance by pressing the power
button (
) and wait for the disc to stop turning. Press
the button on the feed chute lid located near the handle
to unlock and turn the lid counter-clockwise. Lift to
remove from the processor bowl. Using the finger holes,
carefully lift the disc out of the bowl and remove the
spindle.
Fig. 5
Use caution when handling the discs as the blades are very sharp.
Assembly and Use for the Disc Attachments
To Next Page
Loading...
Need help?
General
