11ninjakitchen.com
10 ninjakitchen.com
8 Holding the lid by the handle in the
upright position, place it on top of the
pitcher aligning the arrow ( ) located
on the lid with the arrow ( ) located on
the pitcher’s handle. Press the handle
down until you hear a click. The triangles
on the lid and the pitcher handle MUST
be aligned in order for the blender to
turn on.
9 Select the speed that best suits
your needs.
10 When you have reached your desired
consistency, stop the appliance by
pressing the power button ( ) and
wait for the stacked blade assembly to
stop turning.
4 The pitcher can be placed on the motor
base two ways; the handle can be on the
front right corner or the front left corner.
5 Holding the Stacked Blade Assembly
by the top of the shaft, place it onto the
drive gear inside the pitcher. Ensure that
the Stacked Blade Assembly is seated
properly and is standing upright.
6 Add the ingredients to the pitcher,
making sure that they do not exceed the
highest measured marking line on the
side of the pitcher.
7 Plug the power cord into the electrical
outlet and press the power button (
).
1 Place the motor base on a clean, dry, level
surface such as a counter or table top.
2 Align and lower the pitcher onto the
motor base. Handle should be aligned
slightly to the right of the LOCK symbol
on the motor base.
3 Rotate the pitcher clockwise until it
locks in place. You will hear a click when
the lock is engaged.
USING THE BLENDER PITCHER
IMPORTANT: Review all warnings
on pages 4–7 before proceeding.
NOTE: When blending any kind of
liquids, such as mixtures of any drinks
or smoothies, do not exceed the “Max
liquid” mark (64 ounces) on the pitcher.
NOTE: If you need to add additional
ingredients while the appliance is
processing, open the pour spout cap
and pour the ingredients in through
the opening.
IMPORTANT: As a safety feature, the
power button ( ) will flash and the
motor will not work if the pitcher and
lid are not installed correctly. When the
pitcher and lid are installed properly, the
power button ( ) will be solid, indicating
that the appliance is ready for use.
NOTE: The Stacked Blade Assembly will
fit loosely on the drive gear.
NOTE: Pulse ingredients for even
chopping by pressing down in
short intervals.
11 To remove the lid, press the release
button on the lid, pull the lid handle up
to a 90° angle and lift the lid o. Turn
the pitcher counter clockwise and then
lift o the base.
12 Open the pour spout cap and use the
spout to empty liquid contents.
13 For thicker consistencies, remove the lid
and stacked blade assembly carefully
(by its shaft), then empty contents from
the container. To remove the lid, press
the release button on the lid and pull the
lid handle up to a 90° angle and lift the
lid o the pitcher. Then, carefully remove
the Stacked Blade Assembly by the
top of the shaft. Place Stacked Blade
Assembly away from the work area to
avoid accidental contact. Finally, empty
contents from the pitcher.
14 Make sure that the unit is unplugged
when not in use.
15 To release the motor base from the
counter or table top, place your hands
underneath both sides of the motor
base and gently pull the unit up and
towards you.
To Next Page
Loading...
