Ninja Master Prep

10
1-877-646-5288
Using the Master Prep
®
Pitcher
WARNING: DO NOT try to place the blades onto the
power head and then into the Master Prep
®
pitcher.
CAUTION: Blades are sharp! Use extreme caution when
handling the blades. Always hold them by the shaft.
IMPORTANT: Never run the appliance empty.
1 Place the Master Prep
®
pitcher on a clean, dry,
levelsurface.
2 Holding the lower blade by the shaft, place it onto the
spindle pin inside the Master Prep
®
pitcher. (fig. 1)
3 Carefully insert the upper blade over the lower blade
rotating it until it locks onto the lower blade. (fig. 2)
IMPORTANT: Always assemble the blades inside the
container.
1
2
Shaft