18
7. With cap removed, turn Control
Solution bottle upside down.
Gently squeeze one drop of Control
Solution onto a clean tissue. Wipe
o bottle tip with the tissue.
Note:
If Test Strip is removed before testing
is finished, an error message appears.
Release and discard old Test Strip.
Use new Test Strip for testing.
8.
Gently squeeze a drop of Control
Solution onto a small piece of
unused aluminum foil or clear
plastic wrap. Discard foil or plastic
wrap aer use.
Note:
Do not put drop on top of the Test
Strip.
9.
With Test Strip still in Meter, touch
Sample Tip to top of the drop of
Control Solution. Allow drop to be
drawn into Test Strip. Remove Test
Strip from drop when Meter beeps.
Dashes appear across the Display to
show Meter is testing.
Note: If Meter does not beep or begin testing soon
aer drawing up sample, release and discard
Test Strip. Repeat test with new Test Strip. If
problem persists, see Troubleshooting.
10. Aer testing is nished, the result appears in the
display with the Control Symbol.
To Next Page
Loading...
