- 19 -
In this mode, 1:N identification will give you log data of the T&A
without pressing the function Keys (F1~F4). In Auto T&A Mode,
the initial screen will be change as below. In this mode, even
though you try just 1:N identification, you’ll successfully get the log
data that you want. You don’t have to press any function key.
F1
INPUT ID
:
１１－ＪＵＬ ０９：２５：３４
1) How to get in the Auto T&A Mode
At first, you should setect the T&A mode in the menu of the
Function Mode and go to the initial screen. And then press the
function key you want for more than 4 second.
2) How to get out of the Auto T&A Mode
Press the cancel key for more than 1 second.
* TIP : You don’t have to input group ID during user registing,
if a terminal is used in T&A Mode.
To Next Page
Loading...
