- 29 -
n 1:N Timeout Setting
In case of 1:N identification, FAIL message will occur if
identification is not completed within time that specified in Option
menu. This is for avoiding making users wait too long.
Decide whether to use 1:N Timeout. The initial setting is 『ON』.
Move to the value you want to choose with the direction keys and
press the Enter key.
1:N TIMEOUT
1. Use Timeout
ＯＮ ／ ＯＦＦ
Next, you can set timeout value. If you choose『OFF』, this menu
won’t appear. The initial setting is 2 sec.
1:N TIMEOUT
2. Set Timeout
( 2 ? 9 ) : 2
To Next Page
Loading...
