of program2. And goes into the OFFICE mode in the light off.
All keys on the keyboard are divided into None layer and Left FN layer and Right FN
layer, Left FN layer can output only when combine with Left FN,Right FN layer can
output only when combine with Right FN.
When finish the set up of all keys in programming software, to save and synchronize
the configure with keys, single click the “WriteKeys” in the main screen.
Single click the “Read configuration” in the main screen, it will read the
standard configuration of OFFICE mode when under the OFFICE mode and
read custom configuration under custom mode.
When the “M” light is on or flash, the keyboard is under custom mode, all the custom
functions can be used.
Programming Software Main Interface
2.1 single key/ combine keys
1.Single click on the key you need to configure, click “Uni/ combo” in the
“KeySettings” surface.
2.Choose “Single” or “Combo”, single click “Record” to record the keys, combine
keys can record six at most.
3.single click “OK”.
To Next Page
Loading...
