NKE REGATTA - Configure the Constants Calibration File

19 47_processor_Regatta_um_UK_40
SailNetOutIP = 192.168.0.233 ; Recipient IP address (navigation PC)
SailNetOutPort = 4003 ; UDP Port number for SailNet output
SailNetInPort = 4004 ; UDP Port number for SailNet input
6.2 Configure the constants calibration file
Press « Calibration » on the Processor Regatta home page, and then on « Constants ».
It will give you access to the file « Calib.ini », which path is:
ftp://root:pass@192.168.0.232/mnt/flash/processor/constants .
Some constants, not accessible from a Multigraphic ou Multidisplay, can be adjusted
here.
[Constants];
HdgOff = 0.0 ; Offset cap additionnel (degrees)
Magnetic heading offset. It can be added to the one accessible from the Multigraphic or
Multidisplay. It is useful for adding an offset to the hundredth.
MastRotOff = 0.0 ; Offset angle de twist de mat (degrees)
Mast angle Offset. It can be added to the one accessible from the Multigraphic or
Multidisplay. It is useful for adding an offset to the hundredth.
MastDeflOff = 0.0 ; Offset Bascule/Deflection mat (degrees)
WindShear = 0.0 ; Cisaillement Vent Reel additionel(degrees)
Offset which compensates for the actual wind shear angle.
AWSOff = 0.0 ; Offset Vitesse Vent Apparent (noeuds)
Apparent wind speed Offset.
FailSafeBS = 6.0 ; Vitesse bateau secours (noeuds)
Boat speed taken into account in the event of loss of speedometer and speed over ground.