50 47_processor_Regatta_um_UK_40
12. PROCESSOR REGATTA SOFTWARE EVOLUTION
V1.9 30/03/2010
Addition of the True heading and True true wind direction channels
V2.0 - Calculation of the direction of the bottom wind
- Calculation of bottom wind speed
- Auto-detection of 3D hull sensor (V1, V2, Compas Regatta, KVH)
- Management of offsets in CAP MAG2 emergency magnetic heading mode
(KVH or NMEA)
- Addition of the autocompensation function of the Regatta compass
- Added management of offset heading, list and pitch in the Regatta
compass
- Added heading, heel and pitch filtering in the Regatta compass
V2.1 - Bug fixes
V2.2 - Modification Management of degraded water speed mode. If US speedo
not hooked, calculation on speed over ground and “Pan” display.
- Authentication of the elements of the bus when the list is created. If the
firmware is not up to date, the Processor does not start.
- Modification of the management of the blue control led
V2.3 - Limitation of heel angle calculation to a maximum of 60 °
- Limitation of the pitch angle calculation to a maximum of 40 °
- Added error message when 3DH data is outliers
V2.4 12/07/2011
- Compatibility with Topline GPS
V2.5 15/10/2012
- Compatibility with the latest 3DH V2 firmware
- Correction of sign error on pitch
- Addition of the Graphic Multifunction authentication
V2.6 - Correction of the loss of an NMEA source after a timeout (example during a
GPS stall)
V2.7 - Addition of identifiers of wifi interfaces
- Quick scan of the Multifunction graphic for the pilot
V3.2 28/10/2013
- Fixed a bug on wind noise reduction.
- Wind noise reduction coefficients, to be set in "Constants" according to the
compass sensor:
V3.7 14/09/2015
- Compatibility with 3D Fusion
- Fixed Processor crash when NMEA baudrate is incorrectly configured
- Not compatible with Sailtune V2.1
V3.9 12/09/2016
- Compatibility with 3D sensor V3
- Compensation available from the processor web page (for 3D Sensor V3)
- Compatibility with Loch paddle wheel
V4.0 07/02/2019
- Compatibility with Multidisplay and Pad
- Compatibility with the latest 3D Sensor V3 in automatic detection
To Previous Page
Loading...