For depth information it is able in the sonde to activate a calculated depth parameter based on the
UNESCO equation.
Pressure measurement is done at the upper tap of the sonde. There is therefore a position offset
between the pressure measurement and the measurements made by the sensors. They don't have
all the same offset:
1.4 Cleaning device
The WiMo and WiMo Plus sondes allow a cleaning device on their location. This device is a smart
wiper. It self-configures according to the sensors that are connected to the sonde. It automatically
detects whether the sensors need or can be cleaned and adjusts its wipe accordingly.
You must take care to avoid having a sensor that should be wiped below the brush in the standby
position.
1.4.1 Installation on a WiMo probe
On version 4 slots (WiMo) the wiper can be placed on any location.
To Next Page
Loading...
