NKE WiMo - Management of alarm files

WiMo / WiMo Plus Multiparameters Sondes
30
Management of alarm files
MEASURE
eS0
Sampling Type (continuous…)
START
eS0
Start mode (manual, on date, on condition)
STOP
eS0
Stop mode (manual, on date, on condition)
EXPORT
eX0
Data export type
eX1
Decimal separation (point or comma)
eX2
Separation of fields (space, tab, semicolon)
DATA
eD0
Recording period
eD1
Starting date (ISO-8601)
eD2
Stopping date (ISO-8601)
eD3
Number of records
7 Management of alarm files
There are different sources of alarms managed by the probe:
- System supervisor alarms (eg low battery voltage).
- Sensor alarms (e.g. brush blockage).
- Communication system alarms (eg: GPS loss).
The table below lists the code of the alarms that are likely to be transmitted
Code
Commentaires
I990
System power-on information
I991
External power supply presence information
I992
Low internal temperature information
I993
High internal temperature information
Défauts
D990
Low battery voltage fault
D991
Brush position fault incompatible with the sensor positions
D992
Low remaining battery capacity fault
D993
Memory card access fault
D994
Low remaining memory capacity fault
D995
GPS drift fault
Défaillances
Fxx0
I2C command write failure with sensor « xx »
Fxx1
I2C configuration write failure with sensor « xx »
Fxx2
Failure to read I2C result with sensor « xx »
Fxx3
I2C no response failure with sensor « xx »
Fxx4
Failure during I2C acquisition with sensor « xx »
Fxx5
I2C result failure with sensor « xx »
Fxx6
I2C cleaning failure with broom « xx »