1 HOW TO USE THE REPAIR PARTS CHAPTER
TO ORDER REPAIR PARTS, call NMC-WOLLARD, Inc. Customer Service at
1-715-835-3151. Be prepared to supply the model number and serial number of your
machine. Inform the Customer Service Representative what page and figure number
the part you require is on, along with the date that appears in the footer of the parts
page. Then order the part number that is listed for the item you require. For your
convenience, Visa and MasterCard are accepted for payment.
VENDOR PART NUMBER column lists the original manufacturers’ part numbers of
items purchased by Wollard. Although these parts may be purchased from Wollard by
using the Wollard part number, you may wish to purchase directly from the original
manufacturer.
ABBREVIATIONS may be used in this manual as follows:
NOMENCLATURE column contains the part description required for identification or
procurement. If the part is an item purchased by Wollard and has not been modified by
Wollard, then following the description will be the vendor’s federal supply (CAGE)
code. If a vendor does not have a CAGE code, a number will be assigned by Wollard
with the prefix letter “V”. Example: V1234. Where there is no vendor or CAGE code,
Wollard Airport Equipment Co. is the manufacturer.
EFF (Effectivity) column identifies by code the model or serial number/s on which a
particular part is used. Absence of the code in the “EFF” column indicates that the part
or assembly is used on all models with Ser #001 and on.
See the Introduction for Effectivity Code and Serial Numbers
CHAPTER 4 REPAIR PARTS AUGUST 31, 2005
1 HOW TO USE THE REPAIR PARTS CHAPTER PAGE 1
Truck Mounted Passenger Stair TMPS-200 Manual No. 307559
A/R As Required
COMM Commercial Item Readily
Available From Local
Sources
DPST Double-Pole Single-Throw
HHCS Hexhead Capscrew
ID Inside Diameter
LH Left-Hand
NS Not Shown
OA Over-All
OD Outside Diameter
RH Right-Hand
RHMS Roundhead Machine Screw
SHCS Socket Head Capscrew
SPDT Single-Pole Double-Throw
To Next Page
Loading...