14. Hold the deflector shield in place on top of the fan shroud before
snapping into place, noting where it contacts the intercooler tube or the
clutch pulley. Trim away that portion of the shield. Snap the shield into
place making sure it does not make contact. See figure 7.
15. Reconnect the battery.
16. Run the engine and check for any clearance or alignment problems.
Adjust as needed.
Truck Mounted Passenger Stair TMPS-200 Manual No. 307559
SEPTEMBER 30, 2008 CHAPTER 2 MAINTENANCE
PAGE 18 3 REMOVAL AND INSTALLATION
To Next Page
Loading...