PBX installation
15
Copyright
© 2003 Nokia. All rights reserved.
■ Connecting the Nokia 32 terminal to a PBX trunk line
The pins number 3 and 4 are TIP and RING. The leftmost pin in the connector is the
ground connector. Connect pin 1 to the ground if the mains voltage might be a
source of interference.
1 Disconnect the power supply of the Nokia 32 terminal from the AC wall outlet.
2 Connect the Nokia 32 terminal to the PBX trunk line using an RJ-11 cable.
3 Connect the power supply to the Nokia 32 terminal.
When light indicator 1 lights up, the network connection is established. When
light indicator 2 lights up, the PBX trunk line connection is established.
If the AutoPIN feature is active, the Nokia 32 terminal attempts to connect to the
network within 20-30 seconds. If the AutoPIN feature is not active, light indicator
2 starts to blink and you must enter your PIN code before the network connection
can be established.
Eppu_en1.fm Page 15 Thursday, January 8, 2004 3:48 PM
To Next Page
Loading...
