PBX installation
17
Copyright
© 2003 Nokia. All rights reserved.
connected before an outgoing call can be made. When the PBX sends a number to
the Nokia 32 terminal, the Nokia 32 terminal connects the call.
■ Connecting the Nokia 32 terminal to a PBX extension
line
Note: Only an analog extension interface can be connected to the
extension connector.
Only pins 3 and 4 are used as A and B.
In the figure on page 14, the pin numbers correspond to the physical
connector, not the wire itself.
The line impedance of the Nokia 32 terminal is 600 Ù and the maximum
line current is 120 mA.
1 Disconnect the power supply of the Nokia 32 terminal from the AC wall outlet.
2 Connect the Nokia 32 terminal to the PBX extension line using an RJ-11 cable.
3 Connect the power supply to the Nokia 32 terminal.
If the AutoPIN feature is active, the Nokia 32 terminal attempts to connect to the
network within 20-30 seconds. If the AutoPIN feature is not active, light indicator
2 starts to blink and you must enter your PIN code before the network connection
can be established.
When light indicator 2 lights up, the network connection is established. When
light indicator 3 lights up, the PBX extension connection is established.
Eppu_en1.fm Page 17 Thursday, January 8, 2004 3:48 PM
To Next Page
Loading...
