Copyright © 2003 Nokia. All rights reserved.
Menu functions
104
Menu functions
3. Scroll to the set you would like to activate and press Activate.
4. Select Edit active service settings.
Select each of the following service settings one by one and key in all the required settings.
• Settings’ name - Key in the new name for the connection set and press OK.
• Homepage - Key in the homepage address of the WAP service that you want to use, press
for a dot, and press OK.
• Session mode - Select Permanent or Temporary.
• Connection security - Select On or Off.
When the connection security is On, the phone tries to use a secure connection with the WAP
service. If a secure connection is not available, the connection will not be made. If you wish to
connect anyway, with a non-secure connection, you must set the connection security to Off.
• Data bearer - Select GSM data or GPRS. Settings for the selected bearer, see Settings when GSM
data is the selected data bearer and Settings when GPRS is the selected data bearer below.
For pricing, connection speed and other information, contact your network operator or service
provider.
Settings when GSM data is the selected data bearer
• Dial-up number - Key in the phone number and press OK.
• IP address - Key in the address, press for a dot, and press OK. You obtain the IP address from
your network operator or service provider.
• Authentication type - Select Secure or Normal.
• Data call type - Select Analogue or ISDN.
To Next Page
Loading...
