Nokia 6620 - Write Text

Nokia 6620 User Guide 47 Copyright © 2004 Nokia
Messaging
• WRITE TEXT
You can key in text in two different ways, using the method traditionally used in
mobile phones or another method called predictive text input.
Traditional text input
The indicator is shown on the top right of the display when you are writing
text using traditional text input.
Press a number key (1–9), repeatedly until the desired character appears. Note that
there are more characters available for a number key than are printed on the key.
Icons: and indicate the selected case. means that the first
letter of the next word is written in upper case, and all other letters will
automatically be written in lower case. indicates number mode.
To insert a number, press and hold the corresponding number key.
To switch between letter and number mode, press and hold the # key.
If the next letter is located on the same key as the present one, wait until the cursor
appears (or scroll right to end the time-out period), and then key in the letter.
If you make a mistake, press the Clear key to remove a character. Press and hold
the Clear key to clear more than one character.
The most common punctuation marks are available under the 1 key. Press the 1 key
repeatedly to reach the desired punctuation mark. You can also press the * key to
open a list of special characters. Use the joystick to move through the list and press
Select to select a character.
To insert a space, press the 0 key. To move the cursor to the next line, press the
0 key three times.
To switch between upper and lower case, press the # key.
Reports (network service)—You can request the network to send you a
delivery report of the text messages, smart messages, and multimedia
messages you have sent. To turn on delivery report reception, go to the
Messaging main menu, select Options > Settings > Text message or
Multimedia message, and select Receive report > Yes.
It might not be possible to receive a delivery report of a multimedia
message that has been sent to an e-mail address.
Before you create a multimedia message, write an e-mail, or connect to
your remote mailbox, you must have the correct connection settings in
place. See "Write and send messages" on page 50. See "Settings needed
for multimedia messaging" on page 51.
6620.ENv1_9310640.book Page 47 Wednesday, May 5, 2004 2:44 PM