76 Copyright © 2004 Nokia
Add a voice command to an application
To add a voice command to a profile, the Profiles folder must be opened and a
specific profile selected.
1 In Voice commands, scroll to the application to
which you want to add a voice command, and
select Options > Add voice command.
Press ’Start’, then speak after tone
is displayed.
2 Press Start to record a voice command.
The phone sounds a starting tone, and the
note Speak now is displayed.
3 Say the voice command.
The phone will stop recording after approximately
5 seconds. After recording, the phone plays the
recorded command. Voice command saved is displayed, and a beep sounds.
A symbol can be seen next to the application.
If you do not want to save the recording, press Quit before the recording stops.
Add an application to the list
You can assign voice commands to other applications that are not listed in the
Voice commands main view.
1 In the Voice commands main view, select Options > New application.
Available applications are displayed.
2 Scroll to the application that you want to add, and press Select.
3 Add a voice command to the new application. See "Add a voice command to
an application" on page 76.
Use a voice command to start an application
1 In the standby mode, press and hold the Right selection key.
A short tone is played, and Speak now is displayed.
2 When you start an application by saying a voice command, hold the phone a
short distance from your mouth, and say the voice command clearly.
The phone plays the original voice command and starts the application.
3 If the phone plays the wrong voice command, press Retry.
6620.ENv1_9310640.book Page 76 Wednesday, May 5, 2004 2:44 PM
To Next Page
Loading...
