Command Reference
7210 SAS M, T, X, R6, R12, Mxp, S, Sx Interface Configuration Guide Page 147
—no encap-type
— hold-time {[up hold-time up] [down hold-time down] [seconds| centiseconds]}
—no hold-time
—no ip-mtu mtu-bytes
— [no] lacp-tunnel
— mac ieee-address
—no mac
— mode {access [uplink] network| hybrid}
—no mode
— monitor-oper-group name
—no monitor-oper-group
— mtu mtu-bytes
—no mtu
— multicast-ingress {l2-mc | ip-mc}
—no multicast-ingress
—no loopback {internal} [service svc-id sap sap-id src-mac SA dst-mac DA]
—no oper-group
— oper-group name
—no poe
— poe [plus]
— qinq-etype 0x0600..0xffff
—no qinq-etype
— [no] report-alarm [signal-fail]
[remote] [local]
— speed {10 | 100 | 1000}
— [no] shutdown
Port Ethernet CRC Monitoring Commands
config
— [no] port {port-id}
— ethernet
— crc-monitor
—[no] sd-threshold threshold [multiplier multiplier]
—[no] sf-threshold threshold [multiplier multiplier]
—[no] window-size seconds
Port Ethernet 802.1x Commands
config
— [no] port {port-id}
— ethernet
— dot1x
— max-auth-req max-auth-request
— port-control {auto | force-auth | force-unauth}
— quiet-period seconds
—[no] radius-plcy name
— re-auth-period seconds
— [no] re-authentication
— server-timeout seconds
—no server-timeout
— supplicant-timeout seconds
—no supplicant-timeout
— transmit-period seconds
—no transmit-period
—[no] tunneling