Nokia 7750 - Page 130

RADIUS Attributes Reference
130
RADIUS ATTRIBUTES REFERENCE GUIDE
RELEASE 14.0.R4
3HE 10793 AAAB TQZZA 01 Issue: 01
44 Acct-Session-Id (RADIUS authentication of data triggered Dynamic Data Services only)
A unique identifier that represents the dynamic service data trigger that
is authenticated. This attribute can be used as CoA or Disconnect
Message key to target the dynamic service data trigger and is reflected
in the accounting messages as attribute [50] Acct-Multi-Session-Id.
87 NAS-Port-Id (RADIUS authentication of data triggered Dynamic Data Services only)
A text string which identifies the physical or logical port of the NAS
which is authenticating the user. Attribute is also used in CoA and
Disconnect Message as identification key. The attribute value is the
dynamic service data trigger sap-id.
95 NAS-IPv6-Address (RADIUS authentication of data triggered Dynamic Data Services only)
The identifying IP Address of the NAS requesting the Authentication or
Accounting. Included when the RADIUS server is reachable via IPv6.
The address is determined by the routing instance through which the
RADIUS server can be reached:
"Management" - The active ipv6 address in the Boot Options File (bof
address ipv6-address).
"Base" or "VPRN" - The ipv6 address of the system interface
(configure router interface system ipv6 address ipv6-address).
The address can be overwritten with the configured ipv6-source-
address (configure aaa radius-server-policy policy-name servers
ipv6-source- address ipv6-address).
26-6527-27 Alc-Client-Hardware-
Addr
(RADIUS authentication of data triggered Dynamic Data Services only)
The MAC address of the dynamic service data trigger frame that
resulted in the authentication. The format is fixed: xx:xx:xx:xx:xx:xx
26-6527-99 Alc-Ipv6-Address (RADIUS authentication of data triggered Dynamic Data Services only)
The IPv6 source address of an IPv6 data trigger frame that resulted in
the authentication. Not included if the data trigger frame is not an IPv6
packet.
26-6527-164 Alc-Dyn-Serv-SAP-Id Identifies the dynamic data service SAP. Only Ethernet ports and LAGs
are valid. The Dynamic Service SAP-ID uniquely identifies a Dynamic
Data Service instance. It can be specified explicitly or relative to the
control channel SAP-ID using wildcards. If explicitly specified, the
Dynamic Data Service SAP-ID and Control Channel SAP-ID do not
have to be on the same port.
The setup of the Dynamic Data Service fails if the SAP specified in [26-
6527-164] Alc-Dyn-Serv-SAP-Id is not created. The Dynamic Data
Service SAP becomes orphaned if the SAP is not deleted with a
teardown action.
Table 39 Dynamic Data Services (Description) (Continued)
Attribute ID Attribute Name Description