RADIUS ATTRIBUTES REFERENCE GUIDE
RELEASE 14.0.R4
RADIUS Attributes Reference
Issue: 01 3HE 10793 AAAB TQZZA 01 169
44 Acct-Session-Id A unique identifier that represents a subscriber host, a set of subscriber
hosts that belong to the same queue-instance or a set of hosts that
belong to a PPPoE or IPoE session. The attribute can have a fixed 22
byte hexadecimal number format or a variable length description format
(configure subscriber-mgmt radius-accounting-policy policy-name
session-id-format {number | description}). For DSM the attribute has
a fixed 10 byte hexadecimal number format with each byte separated
by a hyphen.
This attribute (in number format) can be used as CoA or Disconnect
Message key to target the hosts or session.
45 Acct-Authentic Indicates how the user was authenticated. Attribute is omitted in
accounting via configure subscriber-mgmt radius-accounting-
policy name include-radius-attribute no acct-authentic.
46 Acct-Session-Time Reports the elapsed time in seconds over the course of this service
being provided. When the accounting session time equals zero
(example when the accounting start is followed immediately by an
accounting interim update or by an accounting stop within the same
second), then the attribute is not included.
47 Acct-Input-Packets Indicates how many packets have been received from the user over the
course of this service being provided and included when standard
accounting attributes are configured. (configure subscriber-mgmt
radius-accounting-policy name include-radius-attribute std-acct-
attributes). There is no overflow attribute when attribute wraps around
2^32.
48 Acct-Output-Packets Indicates how many packets have been send to the user over the
course of this service being provided and included when standard
accounting attributes are configured. (configure subscriber-mgmt
radius-accounting-policy name include-radius-attribute std-acct-
attributes). There is no overflow attribute when attribute wraps around
2^32.
49 Acct-Terminate-
Cause
Indicates how the subscriber host or queue-instance or PPPoE/IPoE
session was terminated. An overview of the mapping between [26-
6527-226] Alc-Error-Code / [26-6527-227] Alc-Error-Message and the
corresponding [49] Acct-Terminate-Cause attribute value can be
displayed with the command: tools dump aaa radius-acct-terminate-
cause.
Table 62 Enhanced Subscriber Management Accounting (Description) (Continued)
Attribute ID Attribute Name Description
To Next Page
Loading...
