RADIUS Attributes Reference
240
RADIUS ATTRIBUTES REFERENCE GUIDE
RELEASE 14.0.R4
3HE 10793 AAAB TQZZA 01 Issue: 01
46 Acct-Session-Time Reports the elapsed time in seconds over the course of this service
(L2TP session or L2TP tunnel) being provided.
47 Acct-Input-Packets Tunnel-link and Tunnel level accounting uses the ESM accounting
statistics. For Tunnel Link Stop it reports the input packets for this user
over the course of this service being provided. For Tunnel Stop this
attribute represent an aggregate of input packets of all sessions that
belong/belonged to this tunnel over the course of this service being
provided.
48 Acct-Output-Packets Tunnel-link and Tunnel level accounting uses the ESM accounting
statistics. For Tunnel Link Stop it reports the output packets for this user
over the course of this service being provided. For Tunnel Stop this
attribute represent an aggregate of output packets of all sessions that
belong/belonged to this tunnel over the course of this service being
provided.
49 Acct-Terminate-
Cause
Indicates how the L2TP session or L2TP tunnel was terminated.
52 Acct-Input-
Gigawords
Indicates how many times (zero or more) the [42] Acct-Input-Octets
counter has wrapped around 2^32 in the course of delivering this
service.
53 Acct-Output-
Gigawords
Indicates how many times (zero or more) the [43] Acct-Output-Octets
counter has wrapped around 2^32 in the course of delivering this
service.
55 Event-Timestamp Record the time that this event occurred on the NAS, in seconds since
January 1, 1970 00:00 UTC
61 NAS-Port-Type The type of the physical port of the NAS which is authenticating the user
and value automatically determined from subscriber SAP
encapsulation. It can be overruled by configuration. Included only if
include-radius-attribute nas-port-type is added per application:
configure aaa l2tp-accounting-policy (L2TP accounting). Checked
for correctness if returned in CoA.
64 Tunnel-Type The tunneling protocol(s) to be used (in the case of a tunnel initiator) or
the tunneling protocol in use (in the case of a tunnel terminator). This
attribute is mandatory on LAC Access-Accept and needs to be L2TP.
The same attribute is included on LNS in the Access-Request and Acct-
Request if configure subscriber-mgmt authentication-
policy|radius-accounting-policy policy name include-radius-
attribute tunnel-server-attrs is enabled on LNS. For L2TP Tunnel/Link
Accounting this attribute is always included on LAC and LNS.
Table 72 L2TP Tunnel Accounting (Description) (Continued)
Attribute ID Attribute Name Description
To Next Page
Loading...
