RADIUS ATTRIBUTES REFERENCE GUIDE
RELEASE 14.0.R4
RADIUS Attributes Reference
Issue: 01 3HE 10793 AAAB TQZZA 01 31
26-6527-132 Alc-Access-Loop-
Rate-Down
The actual downstream rate (coded in kbits per second) of a PPPoE
subscriber's synchronized DSL link and competes with the value received
from alternative sources (dsl-forum tags, ludb, ancp). Values outside the
Limits are treated as setup failures. Attribute is silently ignored for None-
MLPPP sessions or IPoE sessions.
26-6527-133 Alc-Access-Loop-
Encap-Offset
The last mile encapsulation representing the subscribers DSL access loop
encapsulation and when returned in RADIUS-Accept (PTA or LAC) is
taken into account for ALE adjust (last mile aware shaping) but not
reflected in [26-3561-144] Access-Loop-Encapsulation (access-loop-
options) send to Accounting. For LAC this attributes maps to LTP AVP
[3561-144] Access-Loop-Encapsulation.
26-6527-135 Alc-PPP-Force-
IPv6CP
Forces IPv6CP negotiation in conditions where no IPv6 related attributes
(such as v6 pool, v6 prefix, v6 address, dnsv6) are obtained via
authentication (Access Accept, local user database, etc.). Without these
IPv6 related attributes, the NAS cannot detect that this is a dual-stack
pppoe user and therefore it will not start IPv6CP negotiation.
An attribute value other from 0 (zero) forces IPv6CP negotiation to start
when no IPv6 attributes are obtained in authentication.
An attribute value of 0 (zero) is treated the same as not sending the
attribute.
26-6527-136 Alc-Onetime-
Http-Redirection-
Filter-Id
The preconfigured ipv4 filter with http-redirection rules. Via this host
specific filter only the first HTTP request from the host will be redirected to
a configured URL with specified parameters. There is no HTTP redirection
for subsequent HTTP requests. Useful in cases where service providers
need to push a web page of advertisement/announcements to broadband
users.
26-6527-160 Alc-Relative-
Session-Timeout
Sets or resets the IPoE/PPPoE session timeout to a relative value (current
session time + newly received Alc-Relative-Session-Timeout). Attribute
equals to [27] Session-Timeout if received in Access-Accept since current
session time portion is than zero. Value zero sets/resets the session-
timeout to infinite (no session-timeout). Simultaneous received [27]
Session-Timeout and [26-6527-160] Alc-Relative-Session-Timeout are
treated as a setup failure (setup failure if received in Access-Accept or
CoA rejected (NAK) with error cause = Invalid Request).
Table 2 Subscriber Host Identification (Description) (Continued)
Attribute ID Attribute Name Description
To Next Page
Loading...
