RADIUS Attributes Reference
32
RADIUS ATTRIBUTES REFERENCE GUIDE
RELEASE 14.0.R4
3HE 10793 AAAB TQZZA 01 Issue: 01
26-6527-161 Alc-Delegated-
IPv6-Prefix-
Length
Defines the IA-PD length information [DPL] and only applicable together
with [26-6527-131] Alc-Delegated-IPv6-Pool (silently ignored if received
in RADIUS Accept without Alc-Delegated-IPv6-Pool). Maps to DHCPv6
vendor-option[17], sub-option[3] pfx-len. The [26-6527-161] Alc-
Delegated-IPv6-Prefix-Length has priority over other possible sources of
DPL. (As a fixed [48 to 64] DPL or variable DPL under configure service
ies |vprn service-id subscriber-interface ip-int-name ipv6 delegated-
prefix-length or on the dhcpv6 server configure router dhcp6 local-
dhcp-server server-name pool pool-name delegated-prefix-length).
DPL values outside the limits are treated as setup failures.
26-6527-174 Alc-Lease-Time Defines the lease-time in seconds for RADIUS proxy and create-host-CoA
scenarios only. The [27] Session-Timeout is interpreted and used as IPoE
lease-time if [26-6527-174] Alc-lease-Time is omitted. Returning attribute
[26-6527-174] Alc-Lease-Time in other scenarios than radius-proxy and
create-host-CoA are treated as setup failures.
26-6527-175 Alc-DSL-Line-
State
Status of the DSL line obtained via ANCP can be one of three value:
SHOWTIME (the modem is ready to transfer data), IDLE (line is idle) or
SILENT (line is silent). Attribute is included/excluded based on configure
subscriber-mgmt authentication-policy/radius-accounting-policy
name include-radius-attribute access-loop-options.
26-6527-176 Alc-DSL-Type Type of the DSL line (ADSL1, ADSL2, ADSL2PLUS, VDSL1, VDSL2,
SDSL, other) obtained via ANCP.
Attribute is included/excluded based on configure subscriber-mgmt
authentication-policy/radius-accounting-policy name include-
radius-attribute access-loop-options.
26-6527-177 Alc-Portal-Url The URL to which traffic matching the host’s IPv4 filter entry with http-
redirect action is redirected to. The URL overrides the configured URL in
the redirect filter. RADIUS overrides must explicitly be enabled: configure
filter ip-filter filter-id entry entry-id action http-redirect rdr-url-string
allow-radius-override.
26-6527-178 Alc-Ipv6-Portal-
Url
The URL to which traffic matching the host’s IPv6 filter entry with http-
redirect action is redirected to. The URL overrides the configured URL in
the redirect filter. RADIUS overrides must explicitly be enabled: configure
filter ipv6-filter filter-id entry
entry-id action http-redirect rdr-url-string
allow-radius-override.
26-6527-180 Alc-SAP-
Session-Index
Per SAP unique PPPoE or IPoE session index that can be included in
RADIUS Access Request messages. The lowest free index is assigned to
a new PPPoE or IPoE session. Attribute is included or excluded based on
configure subscriber-mgmt authentication-policy name include-
radius-attribute sap-session-index.
Table 2 Subscriber Host Identification (Description) (Continued)
Attribute ID Attribute Name Description
To Next Page
Loading...
