Nokia E60 - Page 88

Select WLAN security sett.. and from the following:
• WPA mode — Select EAP (Extensible Authentication
Protocol) or Pre-shared key (a secret key used for
device identification).
• EAP plug-in settings — If you select WPA mode >
EAP, select which EAP plug-ins defined in your device
to use with the access point.
• Pre-shared key — If you select WPA mode > Pre-
shared key, enter the shared private key that identifies
your device to the wireless LAN to which you connect.
• TKIP encryption — To enable TKIP encryption, based
on transient keys changed often enough to prevent
misuse, select Allowed. All devices in the wireless LAN
must either allow or prevent the use of TKIP
encryption.
The settings available for editing may vary.
EAP
To view the EAP (extensible authentication protocol)
plug-ins currently installed in your device (network
service), select Menu > Tools > Settings >
Connection > Access points. Select Options > New access
point and define an access point that uses wireless LAN
as a data bearer and 802.1x or WPA/WPA2 as their security
mode. Select WLAN security sett. > WPA mode > EAP,
scroll to EAP plug-in settings, and press the joystick.
EAP settings
Select Menu > Tools > Settings > Connection > Access
points. Select Options > New access point, or select an
access point and Options >
Edit.
Select WLAN security mode > 802.1x or WPA/WPA2.
Select WLAN security sett. > WPA mode > EAP, scroll to
EAP plug-in settings, and press the joystick.
The extensible authentication protocol (EAP) plug-ins are
used in wireless networks to authenticate wireless
devices and authentication servers, and the different EAP
plug-ins make possible the use of various EAP methods
(network service).
To use an EAP plug-in when you connect to a WLAN using
the access point, select the desired plug-in and Options >
Enable. The EAP plug-ins enabled for use with this access
point have a check mark next to them. To not use a plug-
in, select Options > Disable.
To edit the EAP plug-in settings, select Options >
Configure.
To change the priority of the EAP plug-in settings, select
Options > Raise priority to attempt to use the plug-in
before other plug-ins when connecting to the network
with the access point, or Options > Lower priority to use
this plug-in for network authentication after attempting
to use other plug-ins.
The available options may vary.
See the device help for more information on EAP plugins.
Configurations
To view and delete configurations for trusted servers,
select Menu > Tools > Settings > Connection >
Configs..
You can receive messages from your network operator,
service provider, or company information management
that contain configuration settings for trusted servers.
These settings are automatically saved in Configs.. You
may receive configuration settings for access points,
88
Settings
file:///C:/USERS/MODEServer/zmao/15544327/rm-49_mars/en/issue_3/rm-49_mars_en_3.xml Page 88 Feb 23, 2006 10:58:54 AMfile:///C:/USERS/MODEServer/zmao/15544327/rm-49_mars/en/issue_3/rm-49_mars_en_3.xml Page 88 Feb 23, 2006 10:58:54 AM