Determining the mounting location
48
Nokia FastMile 4G Receiver Installation Guide
3TG-00387-ABBA-TCZZA Issue: 01
10.2 Determining the mounting location for unit
that will be managed by the Nokia Altiplano
FastMile Controller
If the Nokia Altiplano FastMile Controller will be used through NETCONF to remotely
manage the Nokia FastMile 4G Receiver, use the following procedure to use the
Nokia Wireless app, which works in conjunction with the Nokia Altiplano FastMile
Controller and the Nokia FastMile 4G Receiver, to help you determine the mounting
location for the Nokia FastMile 4G Receiver.
The Nokia Wireless app works in conjunction with the Nokia Altiplano FastMile
Controller to find an LTE base station and to set up the Nokia FastMile 4G Receiver.
The Nokia Wireless app works in conjunction with the signal strength measurement
capability of the Nokia FastMile 4G Receiver to find a place to mount the Nokia
FastMile 4G Receiver.
You will need the Nokia FastMile 4G Receiver and a portable battery-powered PoE
injector for this procedure. You might need to provide an Ethernet cable to connect
to the Compact multi-band model of the Nokia FastMile 4G Receiver (the Compact
mono-band and ABA models have a pre-attached Ethernet cable). An appropriate
SIM card must be installed in the Nokia FastMile 4G Receiver as described in
chapter 9.
The Nokia Wireless app must be installed on a mobile phone as indicated in section
8.2 before you can use the app to help you determine the mounting location for the
Nokia FastMile 4G Receiver. As well, you will need the sheet of paper provided with
the Nokia FastMile 4G Receiver that has the QR code for the Nokia FastMile 4G
Receiver.You will need to know the username, password and the FastMile Controller
URL in order to login to the Controller from the Nokia Wireless app. Also you will have
to know the Subscription ID in order to register the receiver to the Nokia Altiplano
FastMile Controller. As well, you will need to allow access to the mobile phone’s
location as part of the procedure. You will also need to know the username and
password to log in to the Nokia FastMile 4G Receiver.
The following need to be considered before you can start to determine the mounting
location of a Nokia FastMile 4G Receiver that will be managed by the Nokia Altiplano
FastMile Controller:
• Follow the steps with exact order described in the procedure
• The installation procedure below will be considered to be successful by the Nokia
Altiplano FastMile Controller when a successful call home is established between
the Nokia FastMile 4G Receiver and the Nokia Altiplano FastMile Controller. In
that case, any second attempt of the installation will not be allowed by the Nokia
Altiplano FastMile Controller. In case there is a need for a second installation,
action on the Nokia Altiplano FastMile Controller is needed to unregister the
subscription ID and perform the installation again.
• You need to finish the Nokia FastMile 4G Receiver installation within 30 minutes
from the time the Nokia Wireless app is connected to the Nokia Altiplano FastMile
Controller, otherwise requests to the Controller will not be authenticated. If more
To Next Page
Loading...
