Nokia FastMile 4G Receiver Installation Guide Determining the mounting location
Issue: 01 3TG-00387-ABBA-TCZZA 75
Figure 35 Screen for sharing location for unit that will be managed by an
ACS
Share your location by tapping on “Next”.
6 Unpack the Nokia FastMile 4G Receiver and connect a portable battery-powered PoE
injector to the Ethernet cable (Compact mono-band and ABA models) or Ethernet port
(Compact multi-band models) of the Nokia FastMile 4G so that the Nokia FastMile 4G
Receiver powers up.
This will allow you to connect the Nokia Wireless app to the Nokia FastMile 4G Receiver so
the Nokia Wireless app can set it up and work in conjunction with it to find the strongest signal
as described in the next steps.
7 The Nokia Wireless app prompts you to connect to the Nokia FastMile 4G Receiver. The
connection will be done through Bluetooth in conjunction with a VPN. You will need to be
close to the Nokia FastMile 4G Receiver and you will need to have Bluetooth enabled on the
mobile phone and accept the pairing request when it appears.
Figure 36 shows the screen to connect to the Nokia FastMile 4G Receiver.
Note — The Bluetooth connection from the Nokia Wireless app towards
the Nokia FastMile 4G Receiver is closed after one hour of inactivity in
order to preserve Nokia Wireless phone resources. There is a
mechanism in place that enables the user to re-establish the Bluetooth
connection when he or she re-enters the app.
To Next Page
Loading...
