Determining the mounting location
62
Nokia FastMile 4G Receiver Installation Guide
3TG-00387-ABBA-TCZZA Issue: 01
 
The screen that shows that the Nokia FastMile 4G Receiver is being set up, and indicates 
the progress of the set up, and indicates that you should keep the Nokia Wireless app open.
After receiving acknowledgment from the Nokia FastMile 4G Receiver of successful receipt 
of the configuration file, the Nokia Wireless app informs you that the setup is complete.
Proceed by tapping on “Done”.
16 The Nokia Wireless app uses the signal strength measurement capability of the Nokia 
FastMile 4G Receiver to help you find a place to mount the Nokia FastMile 4G Receiver.
The Nokia Wireless app provides the following screens to help you find a place to mount the 
Nokia FastMile 4G Receiver based on signal strength measurements:
• swipable information screen that tells you to:
• find a location where the Nokia FastMile 4G Receiver won’t be obstructed (shown in 
Figure 24)
• hold the Nokia FastMile 4G Receiver in place and keep it steady (shown in Figure 25)
• try a few locations to find the best signal (shown in Figure 26)
• screen that starts a signal strength measurement by the Nokia FastMile 4G Receiver; you 
start a measurement by tapping “Measure Signal”; measurements can take up to five 
minutes (shown in Figure 27); for a Compact multi-band model, the signal strength LEDs 
will light
• screen that shows a signal strength measurement in progress; you must wait for the 
measurement to finish
• screen that shows a signal with average strength, with a recommendation that you take 
another measurement 
• screen that shows a signal with strong strength, with an indication that this is a good place 
to install 
• screen that shows a signal with very strong strength, with an indication that this is a good 
place to install (shown in Figure 28)
• screen that shows no signal, with a recommendation that you take another measurement 
When you have a signal strength measurement that is satisfactory, proceed by tapping on 
“Done”.