Determining the mounting location
80
Nokia FastMile 4G Receiver Installation Guide
3TG-00387-ABBA-TCZZA Issue: 01
12 The Nokia Wireless app uses the signal strength measurement capability of the Nokia
FastMile 4G Receiver to help you find a place to mount the Nokia FastMile 4G Receiver.
The Nokia Wireless app provides the following screens to help you find a place to mount the
Nokia FastMile 4G Receiver based on signal strength measurements:
• swipable information screen that tells you to:
• find a location where the Nokia FastMile 4G Receiver won’t be obstructed (shown in
Figure 40)
• hold the Nokia FastMile 4G Receiver in place and keep it steady (shown in Figure 41)
• try a few locations to find the best signal (shown in Figure 42)
• screen that starts a signal strength measurement by the Nokia FastMile 4G Receiver; you
start a measurement by tapping “Measure Signal”; measurements can take up to five
minutes (shown in Figure 43); for a Compact multi-band model, the signal strength LEDs
will light
• screen that shows a signal strength measurement in progress; you must wait for the
measurement to finish
• screen that shows a signal with average strength, with a recommendation that you take
another measurement
• screen that shows a signal with strong strength, with an indication that this is a good place
to install
• screen that shows a signal with very strong strength, with an indication that this is a good
place to install (shown in Figure 44)
• screen that shows no signal, with a recommendation that you take another measurement
When you have a signal strength measurement that is satisfactory, proceed by tapping on
“Done”.
To Next Page
Loading...
