Nokia Mobile Phone - Settings; Application Settings; Device and SIM Card Security; Common Accessory Settings

Settings
Application settings
Select > Settings > Settings and Applications.
Select an application from the list to adjust its settings.
Device and SIM card security
Select > Settings > Settings > General > Security.
To change the PIN code, select Phone and SIM card > PIN
code. The new code must be 4 to 8 digits long. The PIN code
protects your SIM card against unauthorised use and is
provided with the SIM card. After three consecutive incorrect
PIN code entries, the code is blocked, and you need to use the
PUK code to unblock it before you can use the SIM card again.
To set the keypad to lock automatically after a defined period,
select Phone and SIM card > Keypad autolock period.
To set a time-out period after which the device is
automatically locked and can be used only if the correct lock
code is entered, select Phone and SIM card > Phone
autolock period. Enter the length of the time-out period in
minutes, or select None to deactiveate the autolock feature.
When the device is locked, you can still answer incoming calls,
and calls may still be possible to the official emergency
number programmed into your device.
To change the lock code, select Phone and SIM card > Lock
code. The default lock code is 12345. Enter the current code
and then the new code twice. The new code must be 4-255
characters long. Alphanumeric (uppercase and lowercase)
characters can be used. The device notifies you if the lock
code is not properly formatted.
Common accessory settings
Select > Settings > Settings and General >
Enhancement.
With most accessories, you can do the following:
To define which profile is activated when you attach an
accessory to your device, select the accessory and Default
profile.
To set the device to answer phone calls automatically after 5
seconds when an accessory is attached, select Automatic
answer > On. If the ringing type is set to Beep once or
Silent in the selected profile, automatic answering is
disabled.
To illuminate the device while it is attached to an accessory,
select Lights > On.
Speech
Select > Settings > Speech.
With Speech, you can set the language, voice, and voice
properties for the message reader.
To set the language for the message reader, select
Language. To download additional languages to your
device, select Options > Download languages. When you
download a new language, you must download at least one
voice for that language.
To set the speaking voice, select Voice. The voice depends on
the selected language.
© 2009 Nokia. All rights reserved.68