Nokia N80 - Page 236

Figure 59 RF Controls window
• WCDMA troubleshooting
i Choose Testing→WCDMA→Tx Control.
ii In the
Tx Control window:
• Select the Algorithm mode tab.
• Set Start level to 0 dBm (Default = 0).
• Set Step size, Step count and Sequence to 0 (Default = 0).
• In the Scrambling code pane set Code class to LONG (Default = LONG), and Code to 16 (Default
= 16).
• For DPDCH set the following values:
• Code number: 0
• Code class: 2
• Weight: 15
• For DPCCH set the following values:
• Code number: 0
• Code class: 2
• Weight: 8
• Set Channel to 9750.
• Check the DPDCH enabled check box (Default).
RM-91; RM-92
Nokia Customer Care RF Troubleshooting and Manual Tuning Guide
Page 7 –20 COMPANY CONFIDENTIAL Issue 1
Copyright © 2006 Nokia. All rights reserved.