• Check the Sweep Mode box.
• Click Tune.
• Setup the signal generator to correspond with the values on the
Rx Calibration
pop-up window and
click OK.
Figure 64 Pop-up window for WCDMA1900
Figure 65 Pop-up window for WCDMA2100
• Ensure Tuning Results are within limits specified in the table above: If values are OK, click Write to save
the values to the phone.
• Close the tuning window.
WCDMA transmitter tunings
Tx AGC & power detector (WCDMA)
Context
Tx AGC & power detector tuning has two purposes:
• to enable the phone to select the correct TxC value accurately in order to produce the required RF level
• to enable the phone to measure its own transmitter power accurately
There are two ways to perform the tuning. For an alternative method, see Alternative steps (page 7–55).
Steps
1. From the Operating mode drop-down menu, set mode to Local.
RM-91; RM-92
RF Troubleshooting and Manual Tuning Guide Nokia Customer Care
Issue 1 COMPANY CONFIDENTIAL Page 7 –49
Copyright © 2006 Nokia. All rights reserved.
To Next Page
Loading...
