All the settings of the N-Com system are managed in this mode.
To access the Configuration Menu starting with the N-Com switched on, press and hold the “” and
“” keys simultaneously for 4 seconds, until the red LED light appears.
Once in the “Configuration” menu, press the “” and “” keys to scroll through the various menu
items.
In the items marked with an “*”, it is possible to enable / disable the function by pressing the “n” key to
confirm.
The following items make up the “Configuration” menu:
A. Speed dial* (chapter 9.1)
B. Smart Navi System* (chapter 9.3)
C. Auto Off*(chapter 4.3)
D. Audio boost*
By enabling the “Audio boost”, all the audio sources inside the device will be reproduced at a
higher and potentially less clear volume.
Press the “n” confirmation key to enable / disable the function, which is not enabled by default on
the device.
E. Language
To change the language in which the system provides voice prompts, please see section 4 of the
Manual.
F. Reset
In order to restore the factory settings of the device, press the “” or “” key until you hear the
voice message “
Factory Reset
”. Press the “n” confirmation key to restore all the factory settings of
the device. The system will shut down automatically.
G. Exiting the configuration
To exit the “Configuration” menu, press the “” or “” key until you hear the voice prompt “
Exit
configuration
”.
Press the “n” confirmation key to exit the “Configuration” menu.
If no key is pressed within 15 seconds, the device automatically exits the “Configuration” menu.
To Next Page
Loading...
Need help?
General
