25
• After a few seconds the systems recognize each other and intercom communication is
established.
14.3. Intercom function
To activate the intercom connection, turn on the two N-Com systems and briefly press the “n” key on
one of the two systems.
N.B.: In case the pre-setting position is empty, or the system being called cannot be
reached within the maximum range or it is already engaged in a phone call, you will hear
an error voice message.
.
15.1. Pairing with the UNIVERSAL INTERCOM
The N-Com system can be paired with the other intercom (from now on referred to as Intercom B) as
if it was a mobile phone.
• Make sure the B602 is turned off.
• Put the B602 system in “Pairing” mode: press and hold the “n” key for 4 seconds, until the red LED
light appears.
• Press the “” key until you hear the voice prompt “
Universal intercom pairing
”.
• Put intercom B in the mobile phone pairing mode. Important: If the intercom allows management
of two mobile phones, put it in pairing mode of the second mobile phone. By doing so, it will be
possible to maintain the connection to your own mobile phone even during intercom
communication (refer to the Intercom B manual).
• On the B602 system, briefly press the “n” key.
• After a few seconds the systems recognize each other and intercom communication is
established.
15.2. Universal Intercom Function
To turn on and off the audio between two helmets, proceed as follows:
From the N-Com B602 system:
Connect or disconnect Intercom B as you would for a regular N-Com intercom (chapter 15).
Intercom B may receive a dialling tone that must be answered with a phone reply command.
To Next Page
Loading...
Need help?
General
