ACCESS GATEWAY
System Administration 121
PPTP CALL ID
IPSEC
4. Click on the Submit button to save your options.
Use the
iNAT Start and iNAT End fields to enter an IP address or range of IP addresses (up
to 50), then click on the
Add button to add the IP address(es), or click on the Remove
button to delete the IP address(es) from the database.
Defining IPSec Tunnel Settings {IPSec}
1. From the Web Management Interface, click on Configuration, then IPSec. The IPSec
Tunnel Settings screen appears:
2. Check the Enable IPsec checkbox to enable IP Security. Note that you will have to reboot
for IPsec to take effect.
3. Check Enable NAT Traversal to allow packets to traverse NAT/IPsec boundaries.
To Next Page
