ACCESS GATEWAY
194 System Administration
3. In the Port field, enter the port (the VLAN ID when using 802.1Q 2-way).
4. In the Description field, enter a meaningful description for this port-location assignment.
5. “Provide DHCP Service” is selected by default. De-select this option if you wish to disable
subscriber-side DHCP for this port location. See “Managing the DHCP service options
{DHCP}” on page 109.
6. Enter a Subnet for the port assignment you are adding.
You must now assign a State for this port-location. Possible states are, No Charge for using
this port-location, Charge for Use, and Blocked. If you do not assign a conditional state,
the state is registered as “No Charge” by default.
7. If applicable, select the Default QoS Policy for the port assignment you are adding.
8. Select the conditional state you want to assign to this port-location.
If you choose Charge for Use additional configurations are available. Refer to the
Note. Port-based Policies should be enabled from the
Configuration->AAA page for
these settings to take effect.
Choose Enable Facebook Login to allow Facebook authentication.
Choose Enable RADIUS Billing if you want RADIUS billing to be enabled on this
port.
Choose Enable PMS Billing if you want PMS based room billing to be enabled on
this port.
Choose Enable Credit Card Billing if you want Credit Card based billing to be
enabled on this port
You can select any number of billing methods per port.
Select from Billing Plan(s) available on port. You can assign a specific billing plan
to a port, enable all existing billing plans, or assign specific billing plans to the port.
Please note that while it is possible to set the value of a per-port configuration parameter
independently of the value of the corresponding global parameter, the feature itself is
disabled for a port unless both the per-port and global parameters are set to enabled. Thus:
RADIUS authentication for a port is enabled only if the RADIUS Client is globally
enabled AND the per-port enable RADIUS billing parameter is set.
Credit card billing for a port is enabled only if Credit Card Services is globally
enabled AND the per-port enable Credit Card billing parameter is set.
All alpha characters (used for locations and descriptions) are case-sensitive.
To Next Page
Loading...
