ACCESS GATEWAY
122 System Administration
4. Click Submit to save the setting.
To add or modify IPsec tunnel peers, see “Managing IPSec Tunnel Peers” on page 122. To
add or modify IPsec security policies, see “Managing IPSec Security Policies” on
page 123.
Managing IPSec Tunnel Peers
You can add a new IPSec tunnel peer or modify the settings of an existing IPSec tunnel peer
from the IPSec Tunnel Settings screen.
Adding a new IPSec tunnel peer
1. Click the Add button in the IPSec Tunnel Peers table. The IPSec Tunnel Peer Settings
screen opens.
2. Enter the IP address of the peer in the Tunnel Peer field.
3. Enter a Dead Peer Detection interval (integer value in seconds).
4. Select the Internet Key Exchange (IKE) Protocol Version.
5. In the Peer Authentication Method section, select one of the two peer authentication
methods:
Authenticate via pre-shared key – Enter the pre-shared key in the Shared Key field.
To Next Page
