Norac Apache UC7 - Software Setup

WWW.NORAC.CA
PRECISIONDEFINED


Page28
Visitwww.solutions.norac.caformoresystem
installationandtroubleshootinginfo.
8  SoftwareSetup
1. Startupthesprayerandtestthesprayer’sfunctionality.Thedisplayterminaldoesnotneedtobepowered
onfortheoriginalboomfunctionswitchestooperate.Unfoldtheboomsandraise/lowereachboomand
themainsection.

Confirmthatthecablingandhosesdonotpinch,stretchorbindovertheentirerangeofmotion.
2. Ifany functionsdonotwork,reviewthehydraulicandelectricalportionsofthismanualto checkforproper
installation.
3. Turnonthepowerforthedisplayterminalusingtheswitchontheside.
4. Theprocedurefortheinstallationofthe UC7™BoomHeightControlsystemisnowcomplete.Beginthe
AutomaticSystemSetupprocedureasdescribedintheUC7TechnicalOperationManual.

