Contents
1 Introduction ................................................................................. 1
2 Materials ....................................................................................... 2
3 CANbus Monitor Parts ............................................................... 3
4 Setting Up .................................................................................... 4
5 Testing UC4+ and UC4 Sensors ................................................ 8
6 Testing UC3 Sensors ................................................................ 12
7 Replacing Transducers ............................................................. 13
8 Replacing O-Rings ..................................................................... 16
9 Frequently Asked Questions .................................................... 17
10 Log Sheet ................................................................................... 19
11 Appendix A – Adjusting 44730 Calibration Stand ................. 23
To Next Page
Loading...
