Norac UC4+ - Hanging the Ystem Ensitivity; Changing between Soil and Crop Mode

9
Sensi 5
Crop on
Soil on
3.7 CHANGING THE SYSTEM SENSITIVITY
A sensitivity setting of 5 (default setting).
• Toggle the "SETUP” switch to view the current Sensi setting.
• While viewing this menu, toggle the " +/- " switch to adjust the
Sensi value.
• Lower numbers reduce system sensitivity and improve stability.
• Increasing the number will increase the response of the system (five is
the default setting).
• If the Sensi setting is modified, the panel will return to the Normal
Operating screen after 3 seconds.
• A lower Sensi setting may be required for stable control at the start
of operation (before sprayer is warmed up).
• As the sprayer warms up increase the Sensi setting until the
performance reaches an optimum level.
• Refer to the UC4+ Operators Manual for a discussion of performance
issues
3.8 CHANGING BETWEEN SOIL AND CROP MODE
System is in CROP mode
System is in SOIL mode
• SOIL or CROP mode can be adjusted in both MANUAL and AUTO
modes.
• To view the current setting, toggle the "SETUP (NO)" switch twice.
• While viewing this menu, use the " +/- " switch to change between
SOIL and CROP mode.
• Wait five seconds for the change to take effect on all sensors.
• If the mode is modified the panel will return to the Normal Operating
screen after 3 seconds.