136
Installing and removing the unit
Installing the unit
2
3
4
mm18 2
53 mm
1
3
1
2
2
Control panel
Control panel
Trim plate
Trim plate
Sleeve
Dashboard
Screw (not included in this
packing)
Sleeve
Bend the appropriate tabs
to hold the sleeve firmly in
place�
Before attaching, make
sure the direction of the
escutcheon is correct�
(Wider hooks on the
bottom side�)
Removing the unit
1 Detach the control panel�
2 Engage the catch pin on the removal tools into the holes on both
sides of the escutcheon, then pull it out�
3 Insert the disassembly tools deeply into the slots on each side,
then follow the arrows instructions as shown on the right�