5 NORD CON Software
BU 0750 GB Technical design subject to change 73
5 NORD CON software
5.1 General
NORD CON is a PC program designed to control and parameter-
ise NORDAC frequency inverters produced by the NORD com-
pany. This software can be installed on any computer with a
Windows 95, 98, NT, 2000, ME or XP operating system.
Installation of the NORD CON software can be performed either
by inserting the NORD PAC CD (part no.: 206099985) or by
downloading the software from the >www.nord.com< Internet
site.
NORD CON provides for accessing up to 31 frequency inverters
simultaneously via their RS485 interface.
To link up the SK 750E with the PC, a SK IC1-232/485 interface
converter (part no. 276970020) and a 300E connecting cable
(part no. 278910060) will be required.
With this software it is not only possible to control and param-
eterise frequency inverters but also to make them read out oper-
ating values. The oscilloscope function integrated in the software
constitutes a very convenient tool with which drive configurations
can be effectively optimised. Like the parameter data records the
oscillograms produced can be stored, edited, and saved.
NOTE: The Internet site from which the NORD CON PC soft-
ware can be downloaded is
>>> www.nord.com <<<
Features
Establish, document, and save the parameter settings of a frequency inverter
Control the connected frequency inverters
Monitor the connected frequency inverters
Oscilloscope function
Produce macros for process sequences on a test basis
Handle remote control of connected frequency inverters
Remote control
To facilitate configuration (parameterisation), the program will present a simula-
tion of the respective control panel enabling operators to carry out remote con-
trol in the same way as if they were programming the device on the spot.
All of the functions available on the inverter's operating unit are available for
remote control as well.
To Next Page
Loading...
